SKY Technology (Shenzhen) Co.,Limited. SKY Technology (Shenzhen) Co.,Limited.
-- Sun readable TFT LCD display with touch panel,E-paper LCD,Graphic LCD display module,Character lcd display module, OLED module
Email Us Add to Favorite
Home About Us Products Service & Support F.A.Q. News Contact Us
Products Catalogue
Full color
Mono color
Contact Us
SKY Technology (Shenzhen) Co.,Limited.
(86)0755-36533558
(86)0755-28759893
MSN Live Help
Skype Live Help
Product Description
3.12 inch OLED display modules with PCB
If you need samples, please click here

For this link, it is only for buy samples, for mass order, we can give you discount.
3.12 inch OLED display modules with PCB
Item No.:  SKYOLED3.2

3.12 inch 16PIN Yellow OLED Module SSD1322 Drive IC 256*64 SPI / 8Bit Parallel Interface

Product Information

Outline size     100.5x33.5x6.3 mm

View Area         78.78x21.18mm

Active Area        76.78x19.18mm

Lattice                256x64 dots

Pixel pitch         0.3x0.3mm

Pixel size           0.28x0.28mm

 

Precautions

First, on with FPC / COF / TCP for OLED products needed in the design of some of the considerations when bending
1 Please note that the design of the FPC bending angle and bending space, do not fold the FPC die . FPC is easy to make too tight bending break , causing no display.
Follow the sections of the modular design of the reference specifications to design the label on the Drawing .
The following figure, and OLED glass edges ≥ 1.83mm, the bending angle was the natural bent.

 

Second, on with FPC / TCP welding of OLED products in some of the considerations
A recommended way of using the Hot-bar soldering yield to ensure
Standard pressure welding conditions: temperature 180-210deg time <10 sec
(2) Use electric soldering iron Instructions:
Before welding Panel checks. Visual inspection , Pin feet without breaking ;
Electrical inspection , testing, screen displays normal welding operation
In the PCB / FPC 's Pin feet evenly on the tin
With a hole on the right place, and fixed FPC / TCP, ensure the welding does not move when
Add flux, using soldering iron tip temperature , temperature 300-350deg.
Repeated soldering should not exceed three times, at the same point dwell time shall not exceed 3 sec, an interval of five minutes each repetition .
After welding inspection. Check Pin foot shift , poor welding , soldering residues, and make appropriate adjustments.
3 . Operation Note :
Using tip soldering iron tip soldering iron can not be used to prevent damage to FPC / TCP Pin directions .
Using heated iron , requiring soldering temperature is too low and will not stick to Pin feet.
Using flux can reduce Weld, or even welding cold welding
Because TCP / FPC 's Pin foot fracture can not be repaired , so when used not bend or pull Pin Pin .

 

Copyright © 2010 SKY Technology (Shenzhen) Co.,Limited. Supported by elut.cnAll rights reserved.